— This is a thematic series of ring gardens. Each ring features a unique skeleton from which metallic flowers bloom.
The series offers limitless scalability—both within the scope of a single jewelry piece (in this case, rings) and in expanding the variation into necklaces and decorative apparel elements.
The «Flower of Eternal Sleep» Ring
The «Necropolis Peony» Ring
The «Flower of Silent Waters» Ring
«Dungeon Heart» Ring
«White Thorn» Ring
ADVERTISEMENT POSTERS
Advertisement Banner
Promotional Poster
Promotional Banner
TECHNICAL SPECIFICATION FOR PRODUCTION
[1] General Information about the Object
The piece is a ring with a complex, organic form featuring floral motifs. A small jewelry series is planned—five variations of the model with different dimensions and shapes.
The item comes into contact with the skin. Further painting is planned.
[2] Dimensions and Size of Works
Ring Size
— Inner Diameter (standard): — Primary Size: 17.0–18.5 mm — Allowed Series Sizes: 16.5 / 17 / 17.5 / 18 / 18.5 / 19 mm
Band Thickness (inner ring)
— Minimum: 1.8 mm — Recommended: 2.2–2.5 mm — Ovality is not permitted
Overall Product Dimensions
— Height of the decorative element: 15–28 mm — Width of the composition: up to 25 mm — Protrusion over the finger: No more than 18 mm for comfortable wear
[3] Design Requirements
All sharp edges must be rounded (radius 2.0–4.0 mm). The minimum thickness of decorative elements is 1.2–2.0 mm. The minimum gap between elements must be greater than 0.5 mm.
Absences:
— sharp needles — closed thin loops — voids without drainage
The inner surface of the ring must be smooth. A light texture is permissible, but no steps are allowed.
[4] Printer Printing Technology
The recommended printing method is SLS printing (PA12 nylon). The printing material is polyamide PA12. This material exhibits high wear resistance, is moisture-resistant, and is non-toxic.
SLS Printing Parameters
- Layer thickness: 0.1 mm (SLS standard)
- Dimensional tolerance: approximately 0.15 mm
[5] Post-production
Mechanical post-processing is required to completely remove the powder. Furthermore, the surface must be sealed with a impregnation agent to ensure safe skin contact and preparation for subsequent priming.
CREATION PROCESS
[1] Concept Model Creation
The Gemini neural network was used to generate the visual elements for the concept. Below is a quick prompt for generating an idea:
«Generate a ring that could be 3D printed. The theme is skeletal colors and bones. The item will be 3D printed, and it must be original. Pay attention to the limitations of 3D printers—single-color printing and detail restrictions. Generate the ring immediately based on the material.»